Hover your mouse over the icon to get more information on the problem. You will notice that a blank square will turn to yellow first and then quickly to green if routing was successful.
In the screenshot this is the position of the green check mark icon. To route audio, click on the square at the crossing.
Before starting to route audio streams let’s make sure that all devices are configured correctly.ĭouble click on any device in the Routing tab and navigate to Device Config to set Sampling Rate (48 kHz in this example) and Latency settings (250 microseconds in this example). Open the Dante Controller on your PC/MAC and navigate to the Routing tab.
#Dante virtual soundcard. how to#
Read more on how to change modes and on what mode is most suitable for your setup… – – If you are unsure about the network switch setting of KLANG:fabrik or KLANG:vier connect your computer running the Dante controller to the Dante port and set the switch configuration mode to “Switch attached Control” to start. With DVS, your computer can be routed with the Dante Controller just like any other Dante equipment. The DVS allows you to send and receive audio with your computer. If you don’t have a mixing console at your fingertips, you can also use and configure KLANG equipment with the Dante Virtual Soundcard (DVS). If you connect a Dante-enabled mixing board, make sure to also connect your PC/Mac running the Dante Controller to the network. Connect Mac/PC with Dante Virtual Soundcard or Dante-enabled mixing board to KLANG:fabrik and KLANG:quelle.
0 kommentar(er)
